How to install your blinds
Most blinds go up with just a screwdriver. Pick your blind for a short video and the steps.
How to install roller blinds
Step 1Screw in the brackets
Hold each bracket in place and put in two screws. We supply colour-matched screws, two per bracket. A manual or electric screwdriver is fine, and there's no need to drill a pilot hole.
Step 2Clip in the blind
The two ends of the tube are different: one has a socket, the other a spring-loaded pin. Put the socket end onto its bracket first, then push the spring end in and let it click into the other bracket.
Step 3Fix the chain to the wall
Screw the supplied chain clip to the wall or frame, leaving a little slack so the chain runs smoothly. It keeps the chain tidy and out of reach of children.
How to install dual roller blinds
Step 1Screw in the brackets
Hold each dual bracket in place and put in two screws. We supply colour-matched screws, two per bracket. No pilot hole needed.
Step 2Clip in both blinds
Fit each blind the same way: socket end onto its bracket first, then push the spring end in until it clicks. The blockout and sunscreen each have their own place on the bracket.
Step 3Fix the chains to the wall
Screw a chain clip to the wall for each blind, leaving a little slack so the chains run smoothly and stay out of reach of children.
How to install venetian blinds
Step 1Screw in the brackets
Inside fit: put the left bracket in the top left corner with two screws, then the right bracket the same way. Check they're level.
Outside fit: fix the brackets at the positions you measured. Pre-drill near the edge of a frame so it doesn't split. On a wall, use packers and longer screws for clearance. Fit the centre bracket too, if there is one.
Step 2Fit the headrail
Unclip the bundle of cords from the top of the headrail and open the latches on the end brackets. Sit the headrail in the brackets with the cords on the correct side, then close both latches until they click.
Step 3Add the pelmet
Peel the tape off the velcro tabs on the headrail, line the pelmet up with the top of the blind and press it on firmly. Then untie the straps, holding the blind as you go. Aluminium venetians don't have a pelmet.
Step 4Raise, lower and tilt
To lower the blind, hold the cords in front of it and pull gently to release. Use the tassels to tilt the slats.
How to install 25mm aluminium venetian blinds
Step 1Screw in the clips
We supply two spring clips that fit the top bar of the 25mm venetian. Screw them to the top of the window, clear of the controls. The end with the bigger curve is the side that screws to the frame.
Step 2Click the blind in
Sit the back lip of the top bar into the clips, then press the top bar up firmly until the clips spring over it and the blind clicks into place.
Good to know
What you need
A screwdriver (manual or electric), a pencil and a tape measure. We supply the brackets and colour-matched screws. For walls rather than timber frames, you may need wall plugs or packers.
Left and right
Chain and cord sides are always as you look at the window from inside the room.
Keeping children safe
Always fit the chain or cord clip that comes with your blind, so loops are out of reach of children.
The blind doesn't sit level
Check both brackets are at the same height with a tape measure from the top of the recess, and that each one is screwed in firmly. Most problems are a bracket a few millimetres out.
Stuck on something?
Send us a question and one of the team will help you get it sorted, usually the same working day.











